Semi-Automatic Round Bottle Labeling Machine for | RFQ Sourcing Details

Machine parameter Single non-positioning label maximum output 50 pcs /min (depending on bottle and label size) Label bottle diameter Ф20-90mm (other models need to be adjusted) Power 50W Power supply 220V±5%50HZ The ambient temperature 5-45ºC R elative humidity 15-90% Overall dimensions (length × width × height) 640×350×460mm Weight 30kg Transmitter parameters Output speed 3-15m/min (10-15bpm) Labeling accuracy (excluding package and label errors) ±0.5mm The minimum length of a label 10mm Working Principle Adopting imported high-precision in to follow the self-adhesive label to rotate the bottle and stick on the bottle.

Common faults Fault Causes and solutions No label coming out The position of the microswitch is incorrect. Adjust the position of the microswitch The microswitch goes wrong . Replace the microswitch The knurled wheel does not compress the label belt and slips when pulling the label.

Tighten the adjustable screw of the drawbar T he power switch is not turned on . T urn on the power switch . More than one label coming out The optical fiber base is incorrectly positioned or the label paper does not pass through the optical fiber base. Adjust the position of the optical fiber base Sensor failure.

Adjust or replace sensors according to item 3.2 of the manual I ncorrect axial position of the label The front and rear positions of the stop rods are not positioned. Lock the stop lever The label is not located on the label stripper plate. Adjust the label position The bottom of the bottle is not attached to the bar.

Can ' t be labeled The reserved label is not long enough. Increase the reserved label length.

The surface of the adhesive is not sticky enough to the label or the humidity is too high The bottle roller does not press down on the attached bottle, and the attached bottle does not roll The label wrinkles after being attached The reserved label is too long.

Reduce the reserved label length There are sundr ies on the surface of the bottle. The distance between the label stripper plate and the rubber roller is too close. Adjust the distance properly T he label is not properly compressed by the pressure plate . T he label which peeled out of is not straight .

A djust the pressure plate to properly press the label The beginning